Extending the service life of bimetallic hammers requires comprehensive optimization from multiple aspects such as material selection, structural design, manufacturing process, and maintenance. The following are specific measures:

1. Material optimization
Reasonably choose material combinations
Bimetallic hammer heads are usually made of high chromium cast iron (wear-resistant layer) and high toughness alloy steel (matrix) composite, ensuring the metallurgical bonding quality of the two materials. It is recommended to choose materials with carbon content matching to avoid cracks or delamination at the interface.
Improve the hardness of the wear-resistant layer
By adding alloying elements such as molybdenum, nickel, and vanadium to optimize the composition of high chromium cast iron, the hardness and impact fatigue resistance can be improved (the recommended hardness is HRC5862).
2. Structural design improvement
Optimize geometric shape
Adopting a trapezoidal or gradient structure to disperse impact stress and avoid stress concentration; Appropriately increase the thickness of the working part of the hammer head to prolong the wear cycle.
Dynamic Balance Design
Ensure the dynamic balance of the rotor system after the installation of the hammer head to reduce additional wear caused by vibration.
3. Manufacturing process control
Composite process optimization
Adopting lost foam casting, liquid liquid composite or inlay casting processes to ensure firm bonding of the bimetallic interface and avoid defects such as cracks and pores.
Heat treatment process adjustment
The wear-resistant layer is subjected to quenching and tempering treatment (such as oil quenching or air quenching), and the substrate is subjected to quenching and tempering treatment to balance hardness and toughness. For example, the quenching temperature of high chromium cast iron layer is 9801050 ℃, and the tempering temperature is 200300 ℃.
4. Usage and maintenance strategy
Regular inspection and replacement
Check the wear of the hammer head every 812 hours of work. When the wear on one side exceeds one-third of the original size or cracks appear, it should be replaced or repositioned in a timely manner (symmetrical installation).
Uniform wear management
Adopting the "group replacement method", some old and new hammer heads are alternately arranged during each replacement to avoid rotor imbalance.
5. Optimization of working conditions
Control material characteristics
The feed particle size should not exceed the maximum allowable value of the equipment (such as ≤ 80mm), and it is recommended to conduct pre screening or reduce the processing capacity for hard materials (such as basalt) first.
Avoid overloading operation
Keeping the motor load at 85% to 90% of rated power, overloading will accelerate the fatigue fracture of the hammer head.
6. Surface strengthening technology
Welding repair
Use wear-resistant welding rods (such as D667) to weld repair the locally worn area, restore the size, and improve the surface hardness.
Laser cladding/coating
Cladding tungsten carbide or ceramic coating on the surface of the hammer can improve wear resistance by more than 30%.
7. Equipment parameter adjustment
Adjust the rotor speed
Appropriately reducing the speed (such as from 1200rpm to 1000rpm) can reduce the impact force, but it is necessary to balance the crushing efficiency.
Optimize the gap between the grate plates
Maintain a reasonable discharge gap (usually 515mm) to avoid the repeated impact of insufficiently crushed materials on the hammer head.
Example application
After adopting the following improvements, the service life of the bimetallic hammer head in the limestone crushing line of a certain cement plant has been extended from 800 hours to 1500 hours:
1. Increase the Cr content of high chromium cast iron from 18% to 26% and add 2% molybdenum;
2. The feed particle size should be controlled within ≤ 50mm;
3. Weld and repair the hammer head after each shift shutdown;
4. Adjust the rotor speed from 1100rpm to 950rpm.
Through systematic optimization, the lifespan of bimetallic hammer heads can typically be increased by 50% to 200%, while reducing equipment downtime and maintenance costs. The key is to choose the most economical and effective improvement combination based on specific working conditions.