About Us About Us
News

Compared to traditional high manganese steel hammers, bimetallic hammers can increase their service

2025-08-21 100

Compared with traditional high manganese steel hammers, bimetallic alloy hammers have significant advantages in wear resistance and service life. The specific comparison is as follows:

image.png

1. Comparison of service life

Bimetallic Hammer Head: Adopting a composite process of high chromium alloy (HRC 62-65) and high manganese steel, the lifespan can reach 3-5 times that of high manganese steel. For example, when crushing high hardness materials such as granite, the service life of bimetallic hammer heads can reach 200-400 hours, while high manganese steel only has 100-200 hours.

High manganese steel hammer head: relying on impact hardening effect, its wear resistance is insufficient under low impact conditions, and its service life is relatively short (such as about 2-3 months for limestone crushing).

2. Performance differences

Wear resistance: The working area of the bimetallic hammer has a higher hardness (HRC 60-65), uniform distribution of carbides, and an increase in wear resistance by 3-5 times; High manganese steel requires strong impact to harden, otherwise it is prone to rapid wear.

Resilience: The bimetallic hammer head balances wear resistance and impact resistance through a composite design (high chromium head+tough handle) to avoid fracture; Although high manganese steel has good toughness, a single material is prone to failure due to uneven wear.

3. Applicable scenarios

Bimetallic Hammer Head: Suitable for high hardness materials (such as basalt, quartz sand) and high impact working conditions.

High manganese steel hammer head: suitable for medium hardness materials (such as limestone) with sufficient impact force.

4. Economic analysis

The initial cost of bimetallic hammer heads is relatively high, but considering the frequency of replacement and maintenance costs, the long-term benefits are better. For example, a certain case shows that its lifespan is 5 times that of high manganese steel, and downtime is reduced by 60%.

5. Industry standards and processes

The bimetallic hammer head must comply with the composite casting process standards (such as GB/T 5680-2010), and the heat treatment process (such as segmented quenching) directly affects its performance; High manganese steel needs to meet the impact hardening conditions (such as GB/T 5680-2010).